If you are unable to discover your RadBeacon proximity beacon using the RadBeacon app, remove and restore power to the device and try again. This feature is a security precaution to limit the possibility of third-party manipulation of your RadBeacons once they have been installed and configured. After this 30 minutes period elapses, the RadBeacon will no longer be connectable from other Bluetooth 4.0 devices. RadBeacons are only configurable for a period of 30 minutes after they are initially powered. Bring your transmitter and receiver closer together. Having the weakest power output configured is the most likely cause of your issue. It is highly recommended that you make a priority of changing the PIN for your RadBeacon. Since your detection rate is much lower, you may want to try a number of things: Increase your transmitter power level from -18 dBm to 3 dBm. In the case of an 8 digit pin, that would be 00000000. The factory default PIN is all zeros, so in the case of a 4 digit pin, that would be 0000. Once discovered, you can display each beacon's operating settings and make modifications to those settings.Ĭonfiguration of a RadBeacon proximity beacons requires a PIN of four (4) or eight (8) digits depending on the model and firmware version. To determine a suitable Transmit Power, you can tap Actions in the top-right of the screen and then tap Range in the action menu. Radius Networks sells two versions of the Dot: Non-configurable (11) and Configurable (14). The app will ask for the Dot’s PIN, which by default is 00000000 (eight zeros). Get the RadBeacon Dot workingownload the RadBeacon app from the Apple app store. If it asks to calibrate to the measured power. But the type is always iBeacon no matter what combination of Alt EddystoneUUID EddystoneURL I select and write. The app will ask for the Dot’s PIN, which by default is 00000000 (eight zeros). It saves the URL power levels, rate and UUIDs. With the RadBeacon app you can scan for nearby configurable Radius Networks beacons. The beacon did not save the TYPE using the android app RadBeacon version 1.2 on android 5.1. Solid configuration app (though I wish the user customized name would show in the beacon list) The company accidently sent me a batch intended for another customer with a pre-programmed PIN, so I was unable to edit my beacons, but they answered my support ticket within a. In all cases the hardware platform must be equipped with Bluetooth 4.0 capabilities. bought the RadBeacon to solve that problem, and have been very pleased. The RadBeacon app from Radius Networks is supported on iOS 7.1 or higher, Android 4.3 or higher and OS X 10.9 or higher. I have an bare-bones app you can run on Android to do this here, but you'll need a copy of Android Studio to build and run it.The RadBeacon Config App is the configuration utility for RadBeacon proximity beacons from Radius Networks that support Apple's iBeacon™ proximity services and Radius Networks AltBeacon™ proximity services, as well as other emerging proximity services. If the above two suggestions don't help, I would use an independent tool such as an Android phone to actually count the number of BLE packets detected. Bring your transmitter and receiver closer together.Increase your transmitter power level from -18 dBm to 3 dBm.Since your detection rate is much lower, you may want to try a number of things: Under good conditions (close range, high transmitter power), I typically see 80-90% of packets get detected by Android and iOS devices which allow you to easily count individual BLE packets. Antennas on both transmitter and receiver.The actual percentage received depends on a number of factors including: Not 100% of advertising packets send out by a Bluetooth LE device will be detected by receiving devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |